activating opencl in darktable
Using OpenCL in darktable requires that your PC is equipped with a suitable graphics card and that it has the required libraries in place. Most modern graphics cards from NVIDIA and AMD come with full OpenCL support. The OpenCL compiler is normally shipped as part of the proprietary graphics driver and is used as a dynamic library called
libOpenCL.so. This library must be in a folder where it can be found by your system’s dynamic linker.
When darktable starts, it will first try to find and load
libOpenCL.so and, on success, check if the available graphics card comes with OpenCL support. A sufficient amount of graphics memory (1GB+) needs to be available for darktable to take advantage of the GPU. If that check passes, darktable tries to setup its OpenCL environment: a processing context needs to be initialized, a calculation pipeline to be started, OpenCL source code files (extension is
.cl) needs to be read and compiled and the included routines (called OpenCL kernels) need to be prepared for darktable’s modules. If all that completes successfully, the preparation is finished.
By default OpenCL support is activated in darktable if all the above steps were successful. If you want to de-activate it you can do so in preferences > cpu/gpu/memory. This configuration parameter is greyed out if the OpenCL initialization failed.
You can switch OpenCL support off and on at any time without requiring a restart. Depending on the type of modules you are using, you will notice the effect as a general speed-up during interactive work and export. Most modules in darktable can take advantage of OpenCL but not all modules are demanding enough to make a noticeable difference. In order to feel a real difference, use modules like shadows and highlights, sharpen, lowpass, highpass or even more extreme contrast equalizer and denoise (profiled).
If you are interested in profiling statistics, you can start darktable with command line parameters
-d opencl -d perf. After each run of the pixelpipe you will be shown details of processing time for each module plus an even more fine-grained profile for all used OpenCL kernels.
Besides the speed-up you should not see any difference in the results between CPU and GPU processing. Except for some rounding errors, the results are designed to be identical. If, for some reason, darktable fails to properly finish a GPU calculation, it will normally detect the failure and automatically (and transparently) fall back to CPU processing.